Description
Connection set PE pipe to drip/supply pipe
Selected brand articles: HTC clamp fitting on NDS AGRIFIM pressure-regulating filter with drip/supply pipe clamp, optimally protected in the NDS valve shaft
The PE to drip/supply pipe connection set from the PROFI Distributor series is installed upstream of your drip irrigation zone in your garden irrigation system.
The set contains all the necessary units to create a connection between your distributor station with outgoing PE pipe and your drip/supply pipe. As drip irrigation is operated at 2 to 3 bar and the fine drip outlets must be protected against particle contamination, the set includes a pressure-regulating filter at 2.1 or 2.8 bar. If you use a connection without pressure regulation or pre-filtration, it is necessary to install the pressure regulation or filtration elsewhere.
- Inlet for PE pipe 25mm or 32mm as selected
- Pressure regulating Y-filter to 2.1 or 2.8 bar depending on selection, stainless steel mesh cartridge 200 mesh
- Outlet pressure 3/4" version: 2.1 bar, flow rate up to 1,137 l/h
- Outlet pressure 1" version: 2.8 bar, flow rate up to 3.407 l/hClamp
- on drip/supply pipe 16/17mm outer diameter
- High-quality, impact-resistant valve shaft from NDS (if selected with valve shaft)
- Important: The pressure-regulating filter can only be operated after a solenoid valve or other control valve, as it must not be under constant pressure.
Provider identification:
HTC
Norisstraße 4
91257 Pegnitz
E-Mail: info@ht-connect.de
Media
There are currently no media files available.